3.5" Backplane With Expander Jumper Settings - Dell PowerEdge C6145 Hardware Owner's Manual

3.5" Backplane With Expander Jumper Settings

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
Figure 5-18. Jumpers Installed on 3.5" Backplane With Expander
Table 5-3. Jumpers Installed on 3.5" Backplane With Expander
Jumper Function
A Project_select <1>
B Project_select <0>
C BOB_UART_SEL
D NC_J14_PIN7
NOTE: The * in the table of backplane jumper describes the default status
and the default state is not active state.
244 | Jumpers and Connectors
Off
Reserved for factory setting
Reserved for factory setting
*General UART Port
Selected
On
Reserved for factory
setting
Reserved for factory
setting
Serial Debug Port
Selected
No function