Fan Controller Board; Removing The Fan Controller Board - Dell PowerEdge C6145 Hardware Owner's Manual

Item Cable
cables
Hard-drive
backplane
power cables

Fan Controller Board

Removing the Fan Controller Board

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 174.
3 Disconnect the cables from the power distribution boards.
4 Disconnect the cables from the fan controller board. See Figure 3-48.
Note the routing of the cable underneath the tabs on the chassis as you
remove them from the system. You must route these cables properly
when you replace them to prevent the cables from being pinched or
crimped.
5 Reconnect the cables from the power distribution boards.
6 Remove the screw securing the fan controller board to the chassis. See
Figure 3-47.
192 | Installing System Components
From
(Power Distribution
Boards)
Hard-drive backplane
power connectors (J5)
To
Backplane