Table of Contents
Advertisement
The green image drum surface at the base of each
cartridge is very delicate and light sensitive. Do not
touch it and do not expose it to normal room light for
more than 5 minutes. If the drum unit needs to be out
of the MFP for longer than this, please wrap the
cartridge inside a black plastic bag to keep it away
from light. Never expose the drum to direct sunlight
or very bright room lighting.
5.
Locate the two fasteners (5) at each side of the belt and
the lifting bar (6) at the front end.
6.
Turn the two fasteners 90° to the left. This will release the
belt from the MFP chassis.
7.
Pull the lifting bar (6) upwards so that belt tilts up towards
the front, and withdraw the belt unit from the MFP.
8.
Lower the new belt unit into place, with the lifting bar at
the front and the drive gear towards the rear of the MFP.
Locate the drive gear into the gear inside the printer by
the rear left corner of the unit, and lower the belt unit flat
inside the MFP.
CAUTION!
5
6
5
Maintenance > 129
Advertisement
Table of Contents
