Actuator Regi - Epson EPL-N2050 Service Manual

EPSON EPL-N2050

4.2.44 Actuator Regi

4.2.44.1 Removal
1. Remove the Cover Assy Front (Section 4.2.3).
2. Remove the Cover Front L/H (Section 4.2.5).
3. Remove the Chute MBF Assy (Section 4.2.30).
4. Remove the Shaft 14 (Section 4.2.51).
5. Remove the Gear 14 (Section 4.2.51).
6. Remove the P/H Assy (Section 4.2.42).
7. Open upward the Chute Upper together with Holder Toner Sensor from
the P/H Assy.
8. Disengage the right hook of Spring Sensor Regi from the P/H Assy.
9. Holding the operating lever of Actuator Regi, move it to the left to remove
the right shaft of Actuator Regi toward the upper right from the P/H Assy.
10. Remove the Spring Sensor Regi inserted in the shaft of Actuator Regi.
4.2.44.2 Assembly
1. Insert the Spring Sensor Regi into the right shaft of Actuator Regi.
2. Holding the operating lever of Actuator Regi, insert the left shaft into the
left hole in the P/H Assy.
3. Holding the operating lever of Actuator Regi, push the bracket of P/H Assy
with the left shaft to deflect, and insert the right shaft of Actuator Regi
into the right hole in the
P/H Assy.
4. Engage the left hook of Spring Sensor Regi with the back of operating
lever of Actuator Regi, and engage the right hook with the right hole in
the P/H Assy.
5. Close downward the Chute Upper together with Holder Toner Sensor
from the P/H Assy.
6. Mount the P/H Assy.
7. Mount the Gear 14.
Disassembly and Assembly
8. Mount the Shaft 14.
9. Mount the Chute MBF Assy.
10. Mount the Cover Front L/H.
11. Mount the Cover Assy Front.
Disassembly and Assembly
Figure 4-61. Actuator Regi Removal
Revision B
158