Connections; Connecting To A Tv - FUNAI WD6D-D4413DB Owner's Manual

Connections

Connecting to a TV

Connect the unit to a TV after considering the capabilities of
your existing equipment.
Before installation, unplug your TV and
this unit
Cable
Signal
Antenna
or
RF cable
(not supplied)
1
Connect the antenna or cable to the ANTENNA
IN jack of this unit.
2
Connect the ANTENNA OUT jack of this unit to
the Aerial jack of your TV.
Using the Scart socket
Audio/video cable
(not supplied)
Scart/RCA cable (not supplied)
Scart adaptor
(not supplied)
Connect AV1 (TV) Scart socket of this unit to
the Scart socket of your TV.
Note
• If your TV does not have a Scart socket, use a Scart/RCA
cable to connect.
• Connect this unit directly to the TV. If the AV cables are
connected to a VCR, pictures may be distorted due to the
copy protection system.
1
To Aerial jack
RF cable
(supplied)
2
Scart cable
(not supplied)
• Analogue teletext can only be output in VCR mode through
AV1 (TV) out. Use TV remote control to decode the
analogue teletext.
• When changing the "Video Out" setting ("SCART (RGB)",
"Component (Interlace)" or "Component (Progressive)"),
connect to the corresponding jack on the TV. If the setting is
changed, for example, to "Component (Interlace)" or
"Component (Progressive)" while the scart cable is
connected to the TV, a distorted video signal may be output.
Using the COMPONENT VIDEO OUT
Jacks and the AUDIO OUT (L R) Jacks
If your TV has component video input jacks, use a component
video cable (to connect the COMPONENT VIDEO OUT jacks)
and an audio cable (to connect the AUDIO OUT (L/R) jacks).
When using this type of connection, "Video Out" setting
should be set to "Component (Progressive)" or "Component
(Interlace)". Refer to " Video Out (Default: SCART (RGB))"
on page 67.
• Component connection provides the better quality picture.
Audio IN
Audio cable
2
(not supplied)
1
Connect the COMPONENT VIDEO OUT jacks of
this unit to the component video input jacks of
your TV.
2
Connect the AUDIO OUT (L R) jacks of this unit
to the analogue audio input jacks of your TV.
• After you have made the connections, set the "Video Out"
setting. (See page 67.)
Selecting Progressive Scan (576p/480p or
Interlaced 576i/480i) Playback
• If your TV is compatible with progressive scanning (576p/
480p), connect the TV to the COMPONENT VIDEO OUT
jacks of this unit and set "Video Out" setting to "Component
(Progressive)" in "Setup" menu. (See page 67.) Next, set
your TV to the progressive scan mode.
• If your TV is not compatible with progressive scan, set
"Video Out" setting to "Component (Interlace)".
• Use a commercially available adaptor if the video input jacks
of your TVs or monitors are the BNC type.
• Only component and HDMI connections are compatible with
the Progressive Scan.
Component
video IN
Y P /C P /C
B B R R
Component
video cable
1
(not supplied)
17
EN