Channel Setting - FUNAI WD6D-D4413DB Owner's Manual

Note
If you have a standard TV:
• Select "4:3 Letter Box" for a full width picture with black
bars at the top and bottom.
• Select "4:3 Pan & Scan" for a full height picture with both
sides trimmed.
If you have a wide screen TV:
• Select "16:9 Wide".

Channel Setting

You can retune this unit or edit the channel setting with
following methods.
Auto Tuning (DVB & ANALOG)
DVB ANALOG
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
"General Setting" menu will appear.
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "Auto Tuning (DVB & ANALOG)" using
[K L], then press [ENTER OK].
The unit will start storing channels available in your area.
General Setting
Playback
Display Country
Video Auto Tuning (DVB & ANALOG)
Recording DVB Channel Setup
Clock ANALOG Channel Setup
Channel
DivX
HDMI
DVB Setting
Reset All
Wait for several minutes to finish channel storing.
4
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG.
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
].
Auto Tuning (ANALOG)
ANALOG
Programme the tuner to scan only the analogue channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "ANALOG Channel Setup" using [K L],
then press [ENTER OK].
4
Select "Auto Tuning" using [K L], then press
[ENTER OK].
The unit will start storing channels available in your area.
ANALOG Channel Setup
Auto Tuning
Manual Tuning
Move
Wait for several minutes to finish channel storing.
5
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG.
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
• When "Country" setting is set to "France", sorting of TV
channels from 1 to 6 will be performed automatically as
follows.
1: TF1 2: F2
4: CANAL+ 5: F5/ARTE
Manual Tuning (ANALOG)
ANALOG
You can preset an analogue channel manually and
individually.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "ANALOG Channel Setup" using [K L],
then press [ENTER OK].
4
Select "Manual Tuning" using [K L], then
press [ENTER OK].
5
Select "Position" using [K L], then press [1].
Position
System
Channel
Decoder
Skip
].
3: F3
6: M6
1
L
1
OFF
ON
EN
21