Plugging In The Printer - Epson LQ-300 User Manual

When your printing becomes faint, you need to replace the
ribbon cartridge. To remove the old ribbon cartridge, first
move the print head to the center of the printer. Then grasp
the ribbon cartridge handle on either side and lift it out of the
printer.

Plugging in the printer

1. Make sure the power switch on the printer is turned off. It is
off when the N side of the switch is pressed down.
2. Check the label on the bottom of the printer to make sure
the voltage required by the printer matches that of your
electrical outlet.
c
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
Caution:
If the rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the
power cord.
Setting Up the Printer
1-9