Attaching The Paper Support; Plugging In The Printer - Epson Stylus color 860 Setup Manual

Attaching the Paper Support

Insert the paper support into the slots at the rear of the printer.

Plugging in the Printer

Make sure that the printer is turned off. It is off when the P power
1.
button protrudes slightly from the surface of the control panel.
2. Check the label on the back of the printer to make sure the voltage
required by the printer matches that of the electrical outlet you will be
plugging it into. Also, make sure that you have the correct power cable
for your power source.
c
Caution:
It is not possible to change the printer's voltage. If the rated voltage and
your outlet voltage do not match, contact your dealer for assistance. Do
not plug in the power cord.
3. If the power cord is not attached to the printer, connect it to the AC inlet
on the back of the printer.
4. Plug the power cord into a properly grounded electrical outlet.