Plugging In The Printer; Connecting The Printer To Your Computer - Epson LQ-2080 Hardware & Software Setup

Proof-Abzeichnung:
K. Nishi _______
N.Nomoto _______
J.Hoadley _______

Plugging in the Printer

1.
Make sure the printer is turned off. The printer is off when the surface of the
Operate button is even with the button protectors as shown below.
2.
Check the label on the back of the printer to make sure its voltage matches that of
your electrical outlet. Also make sure the plug on your printer's power cord
matches your electrical outlet.
c
3.
If the power cord is not attached to the printer, plug the appropriate end into the
AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical outlet.

Connecting the Printer to Your Computer

To connect your computer to your printer's built-in parallel interface, you need a
shielded, twisted-pair, parallel cable with a D-SUB, 25-pin, male connector for your
computer and a 36-pin Centronics
1.
Make sure both the printer and computer are turned off. The printer is off when
the surface of the Operate button is even with the button protectors.
Setting Up the Printer
PapU
booklet.fm Rev. A
A5-Format
4/28/99
Caution:
It is not possible to change the printer's voltage. If the rated voltage
and your outlet voltage do not match, contact your dealer for assis-
tance. Do not plug in the power cord.
®
-compatible connector for the printer.
BookletENew.fm
Durchlauf 2
15
R