Options; When You Use The Cut-Sheet Feeder, The Paper Does Not Feed Properly - Epson LQ-300 User Manual

The paper does not eject properly.
When using the pull tractor, tear off the paper entering the
printer, then press the LF/FF button to feed the paper forward.
When using the push tractor, tear off the paper at the last
printed page, then press the Font and LF/FF buttons together to
feed the paper backward.
When you switch between single sheets and continuous paper, the
beeper sounds once and the Pause light comes on.
You may have tried to change the paper-release lever position
while paper remained in the printer. Return the paper-release
lever to the previous position and eject the paper. Then change
the paper-release lever position.

Options

When you use the cut-sheet feeder, the paper does
not feed properly
The paper does not feed.
The cut-sheet feeder may be incorrectly installed. Reinstall it as
described on page 2-29.
Make sure the paper-release lever is pushed back to the
single-sheet position.
You may have loaded too many sheets in the cut-sheet
feeder's bin. Make sure the bin contains no more than 50 sheets.
Troubleshooting
3-9