ETC microVision FX User Manual page 81

Chapter 4 Tutorial
8. Set the switch labeled Rate/Both/Audio to one of the following
9. Set the switch labeled Light/Dark/Off to either Light or Dark to
10. To stop the chase, set the switch labeled Light/Dark/Off to Off.
settings to indicate how you want to control the chase rate:
Rate
If you want to set the rate of the chase manually, set the switch to
Rate, and set the Rate pot to the desired setting. The Rate pot is
marked in increments from 0 to 10. At the 0 setting, the chase
stops; at 10, the chase proceeds at a rate of approximately 15 steps
per second.
Audio
If you want to use a music source to control the chase rate through
your MicroVision FX's audio input connector, set the switch to
Audio. MicroVision FX analyzes the tempo of the music and sets
the chase rate accordingly. (See page 4 - 42 for more information.)
Both
If you are controlling the chase rate with the Rate pot and also want
to use audio control, set the switch to the Both setting. The chase
rate is determined simultaneously by the setting of the Rate pot and
the audio input.
start the chase. This starts the chase running and selects one of the
following chase types:
Light chase
In a light chase, the channels that constitute the step flash on, then
turn off again when the next step begins.
Dark chase
In a dark chase, the channels that constitute the step flash off, then
turn on again when the next step begins.
4 - 39