4. Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). Use M3.5 x 38 mm
(#6 x 11/2 inch) screws with a flat underside and maximum screw head
diameter of 9.0 mm to mount the DCX700.
5. Using a screwdriver, turn each screw until part of it protrudes from the wall,
as shown in the following illustration.
There must be 0.10 inches (2.5 mm) between the wall and the underside of
the screw head.
6. Place the DCX700 so the keyholes on the back of the unit are aligned above
the mounting screws.
7. Slide the DCX700 down until it stops against the top of the keyhole opening.
After mounting, reconnect all cables and plug the power cord into the +5VDC
connector on the unit and the electrical outlet. Route the cables so that they are
not a safety problem.
DCX700 High-Definition Digital Set-Top Box • User Guide
Figure 1 — DCX700 Wall Mounting Template
6.0 mm (.24 inches) maximum
9.0 mm (.35 inches) maximum
2.5 mm (.10 inches).