Wall Mounting Your DCX700
If you mount your DCX700 on the wall, you must:
Locate the unit as specified by the local or national codes governing
residential or business cable TV and communications services.
Follow all local standards for installing a network interface unit/network
interface device (NIU/NID).
If possible, mount the unit to concrete, masonry, a wooden stud, or some other
very solid wall material. Use anchors if necessary (for example, if you must
mount the unit on drywall).
Note: Motorola recommends the use of an External IR receiver Cord (part number
571984) if wall mounting the DCX700.
Make sure the AC power plug is disconnected from the wall outlet and all cables
are removed from the back of the DCX700 before starting the installation.
Do the following to mount your DCX700 on the wall:
1. Use Figure 1 to determine the space required between keyholes.
2. Use a center punch to mark the center of the holes.
3. On the wall, locate the marks for the mounting holes.
DCX700 High-Definition Digital Set-Top Box • User Guide
Before drilling holes, check the structure for potential damage to
water, gas, or electric lines.
If necessary, seat an anchor in each hole.