Advertisement

2
inch
During Installation
Do not place the terminal in an enclosed area where the cooling vents are blocked or impede the flow of air through
the ventilation openings.
Install the terminal so that its position does not interfere with its proper ventilation. For example, do not place the
terminal on a bed, sofa, rug, or similar surface that could block the ventilation openings.
Install the terminal so that there is a minimum of two inches of space between surrounding surfaces and the top,
left, and right sides of the terminal to ensure proper ventilation.
Install the terminal away from heat sources such as radiators, heat registers and stoves. Installation of the terminal
near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as the air
surrounding the terminal does not exceed 40º C (104º F).
Place the terminal on a flat surface not prone to vibration or impact.
Do not place the terminal on top of another electronic device.
Do not install the terminal in an area where condensation occurs.
To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do not plug the AC
power cord into a switched power outlet.
For DCX700 North American models, only use power supplies with Motorola part number 524475-034.
FCC Compliance
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
DCX700 High-Definition Digital Set-Top Box • User Guide
365-095-14284 x.1
V E N T I L A T E
2
POWER
DCX700 M
-
inch space
DATA
LAN
REC
B
2
inch
ii

Advertisement

   Also See for Motorola DCX700

   Related Manuals for Motorola DCX700

Comments to this Manuals

Symbols: 0
Latest comments:
  • Norbert Weiss Nov 12, 2017 06:19:
    Very nice. After many years of connecting devices with unfavorabl​e results, I now have a better understand​ing of what may be wrong or needs adjusting to maximize content. Each feature described is clear and to the point which makes for easy reading.
  • EDGARDO MOLINA ESCOBAR Oct 16, 2014 03:42:
    HOW CAN I remote control to adjust the volume