Pitney Bowes Internet Fax Kit User Manual page 93

19
Select "TTI Type" and press ENTER. The LCD shows:
The machine asks for the type of TTI you want to appear on the faxes that are relayed to other callers.
• Sender — Relay the document with sender unit's TTI (don't send your TTI).
• Both — Relay the document with both the sender unit's TTI and your TTI.
• Yours — Relay the document with your TTI instead of the sender unit's.
20
Using the cursor key, select the TTI you want. Then press ENTER. The LCD shows:
21
Select "Auto Print" and press ENTER. The LCD shows:
ON: Print the document automatically when it's received.
OFF: The machine does not print it, but only relays it to the e-mail address and/or other fax machine.
22
Using the cursor key, select the mode you want. Then press ENTER.
23
Select "Exit" and press ENTER. The LCD shows:
The machine asks for your F-Code box's four-digit security I.D. code. This is the I.D. code for the box's secu-
rity, which you use to enter before you can make any changes to this F-Code box.
Note: If you do not want to set or change the I.D. code, skip to step 26.
24
Decide on a four-digit I.D. code (0001-9999) for this F-Code box. Write it down, and put it in a safe place.
Important: Do not use 0000 as an I.D. code.
25
Use the numeric keypad to enter the four-digit I.D. code for this F-Code box and then press ENTER.
Important: After completing this step, you must know this code to access to this F-Code box. Be sure to
write it down.
26
Press STOP to finish and return to standby.
5.8