Account Activation For Wireless Devices; Resetting The Router - Multitech MultiModem rCell User Manual

Chapter 2 – Installation

At the Password prompt, type the default password: admin (all lower-case). Press ENTER
2.
In the command window, type AT+CSQ . The router responds with the received signal strength (rssi).
10 – 31
0 – 9
99
Once you have a good signal for where you are going to place the router, either refer back to Optional
Mounting in this Chapter if you are permanently mounting your router or continue with Account Activation
for Wireless Devices.

Account Activation for Wireless Devices

Please refer to Multi-Tech's Cellular Activation Web site at
information on activating your cellular modem.
Note: If you need remote access to your MultiModem over the Internet for remote configuration, you need to
ensure that your wireless network provider has provisioned mobile terminated data and fixed or
dynamic public IP address in which they can configure the network to redirect any incoming connection
to that predefined IP.

Resetting the Router

To reset the router:
●
Hold the Reset button in until the Status Light goes out. Then, release it.
This also sets the username and password back to admin and admin and the IP address to the default,
192.168.2.1.
18
Signal Strength – RSSI
Sufficient
Weak or Insufficient
Insufficient
http://www.multitech.com/activation.go
Multi-Tech Systems, Inc. MultiModem rCell User Guide
for