Scanning Bar Codes - Intermec SG10T User Manual

Chapter 2 — Scanning with the SG10T

Scanning Bar Codes

8
When you unpack the SG10T, these bar code symbologies are enabled:
Code 39
•
• Code 128 / GS1-128
• EAN/UPC
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on your SG10T. Use
EasySet version 5.6.4.0 or later (in offline mode only, see
"Configuring Your Scanner with EasySet" on page
and disable symbologies for your scanner. EasySet is available on the
Intermec web site at www.intermec.com/EasySet. Simply download
and install it.
To scan a bar code label with a linear imager
1 Point the SG10T at the bar code label and hold the SG10T at a
slight angle, close enough to the label (a few cm/inches
maximum).
2 Hold the scanner so that the scanner window is as parallel as
possible to the bar code plane, pull the trigger, and direct the red
beam so that it falls across all bars in the bar code label. Try to
keep the beam as parallel as possible to the bar code.
23) to enable
SG10T Tethered Scanner User's Guide