Kodak PS50 Series User Manual page 63

A-61760 September 2012
3. Remove each core assembly by lifting up and out of position and
slide each tire off of the core.
4. Install each new tire by gently pulling it over the core and replace
the core assembly in the feed module.
NOTE: You may need to slide the shaft to the right or left so the
core fits properly within the feed module housing
IMPORTANT:Do not overstretch the tire; it may tear.
5. Reinstall the feed module by aligning the pins and pushing it toward
the left to fit it into position. Be sure the gears are aligned and it
snaps into place. Roll the feed module back into place.
6. Reinstall the feed module cover by aligning the tabs with the slots
and pushing it back into position until it snaps into place.
5-11