Usb/Audio Board - HP Folio 13-2000 Maintenance And Service Manual

4. Remove the WLAN module by pulling the module away from the slot at an angle (4).
NOTE:
memory module slot.
NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the
protective sleeves must be installed on the antenna connectors.

USB/Audio board

Description
USB/Audio board
Before removing the USB/Audio board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the base enclosure screws (see
5. Remove the keyboard (see
6. Remove the top cover (see
7. Disconnect the battery cable (see
Remove the USB/Audio board:
1. Disconnect the USB/Audio board cable from the system board (1)
2. Disconnect the Phillips PM 2.0x2.0 screw securing the USB/Audio board (2).
WLAN modules are designed with a notch (5) to prevent incorrect insertion into the
Keyboard on page
Top cover on page
Spare part number
672358–001
Base enclosure on page
26).
28).
Battery on page 32).
25).
Component replacement procedures 37