Part Identification Chart - Weider 831.15396.0 User Manual

PART IDENTIFICATION CHART

Refer to the drawings below to identify small parts used in assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST on the reverse side of this page. Note: Some small
parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.
M6 Nylon Locknut (69)
19mm Round Inner Cap (78)
25mm Square Inner Cap (54)
45mm Square Inner Cap (42)
50mm Square Inner Cap (98)
M8 Flange Nut (19)
M8 Nylon Locknut (65)
M10 Washer (75)
M10 Nut (47)
M10 Nylon Locknut (76)
38mm Round Inner Cap (38)
38mm x 64mm Inner Cap (41)
38mm x 76mm Inner Cap (99)
M10 Lock Washer (103)
M8 Washer (59)