Part Identification Chart - Weider WEEVBE33110 User Manual

ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (3), slide the desired amount of
weight (not included) onto the weight tube.
WARNING:
Do not place more than
59 kg (130 lbs.) on the Leg Lever (3).
LOCKING THE LEG LEVER
Some exercises, such as sit-ups, can be performed
more comfortably with the Leg Lever (3) locked. To lock
the Leg Lever, turn the Leg lever Lock (2) until it
engages the Short Pad Tube (17).
ATTACHING THE CURL POST
For some exercises, the Curl Post (10) must be
attached to the weight bench. Remove the 45mm
Square Inner Cap (27) and insert the Curl Post into the
Front Leg (4). Slide the M8 Adjustment Knob (26)
through the Front Leg and the Curl Post, and turn it
clockwise until it is tight. Make sure that you fully
tighten the Adjustment Knob.
When the Curl Post (10) is not in use, store the Curl
Post away from the weight bench. Insert the 45mm
Square Inner Cap (27) halfway into the top of the Front
Leg (4).
3
2
3
17
10
26
27
4
12

Part Identification Chart

This chart is provided to help you identify the small parts used in assembly. The number in parentheses below
each part refers to the key number of the part. Important: Some parts may have been pre-assembled for
shipping purposes. If you cannot find a part in the parts bags, check to see if it has been pre-assembled.
M10 x 73mm Bolt (41)
M8 x 67mm Bolt (42)
M10 x 65mm Bolt (15)
M8 x 62mm Bolt (48)
M8 x 60mm Bolt (38)
M8 x 55mm Carriage Bolt (47)
M6 x 40mm Bolt (44)
M8 x 16mm Bolt (39)
M10 Washer (37)
M8 Washer (21)
M6 Washer (36)
M8 Nylon Locknut (40)
M10 Nylon Locknut (49)
M6 x 16mm Bolt (45)
10mm Plastic Bushing (35)
5