Part Identification Chart - Weider WEBE09100 User Manual

Part Identification Chart

Refer to the drawings below to identify small parts used in assembly. The number in parentheses below each
drawing is the key number of the part, from the Part List in the center of this manual. The number following the
key number is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a
part is not in the parts bag, check to see if it has been pre-attached.
10mm Spacer (20)–1 M6 Washer (30)–4
M8 Flat Washer (13)–2
M10 Washer (6)–4
M8 x 58mm Bolt (16)–1
M8 Nylon Locknut (9)–1
M10 Nylon Locknut (11)–8
M6 x 16mm Screw (3)–6
M10 x 22mm Bolt (7)–2
M10 x 58mm Carriage Bolt (8)–2
M6 x 64mm Screw (4)–4
M10 x 65mm Bolt (23)–3
M10 x 180mm Bolt (22)–1
5