D-Link DES-3028 Cli Reference Manual page 66

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show syslog
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:
DES-3028P:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3028P:4#
create syslog host
Purpose
Syntax
Description
Parameters
Used to display the syslog protocol status as enabled or disabled.
show syslog
The show syslog command displays the syslog status as enabled or
disabled.
None.
None.
Used to create a new syslog host.
create syslog host <index 1-4> ipaddress <ipaddr> {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]
The create syslog host command is used to create a new syslog host.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are
four available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages
will be sent.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the
Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
Numerical Facility
Code
62