Introduction - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The Switch can be managed through the Switch's serial port, Telnet, or the Web-based management agent. The Command Line
Interface (CLI) can be used to configure and manage the Switch via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI. Configuration and management of the Switch via
the Web-based management agent is discussed in the Manual. This manual provides a reference for all of the commands contained
in the CLI for members of this series, including the DES-3028, DES-3028P, DES-3052, and DES-3052P. Examples present in this
manual may refer to any member of this series and may show different port counts, but are universal to this series of switches,
unless otherwise stated. Configuration and management of the Switch via the Web-based management agent is discussed in the
User's Guide.
Accessing the Switch via the Serial Port
The Switch's serial port's default settings are as follows:
•
9600 baud
•
no parity
•
8 data bits
•
1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as above
is then connected to the Switch's serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be visible. If this screen does not
appear, try pressing Ctrl+r to refresh the console screen.
There is no initial username or password. Just press the Enter key twice to display the CLI input cursor − DES-3028P:4#. This is
the command line where all commands are input.
Figure 1-1. Initial CLI screen
1
1
I
NTRODUCTION