D-Link DES-3028 Cli Reference Manual page 148

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
DES-3028P:4#create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DES-3028P:4#
config 802.1x guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ports for a previously created 802.1x Guest VLAN as enabled.
DES-3028P:4#config 802.1x guest_vlan ports 1-5 state enable
Command: config 802.1x guest_vlan ports 1-5 state enable
Success.
DES-3028P:4#
show 802.1x guest_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the configurations for a previously created 802.1x Guest VLAN.
Used to configure ports for a pre-existing 802.1x guest VLAN.
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
The config 802.1x guest_vlan ports command is used to configure ports to
be enabled or disabled for the 802.1x guest VLAN.
<portlist> - Specify a port or range of ports to be configured for the 802.1x
Guest VLAN.
all – Specify this parameter to configure all ports for the 802.1x Guest VLAN.
state [enable | disable] – Use these parameters to enable or disable port
listed here as enabled or disabled for the 802.1x Guest VLAN.
Only administrator-level users can issue this command.
Users must have already previously created a VLAN using the create vlan
command. If the specific port state changes from an enabled state to a
disabled state, these ports will return to the default VLAN.
Used to view the configurations for a 802.1x Guest VLAN.
show 802.1x guest_vlan
The show 802.1x guest_vlan command is used to display the settings
for the VLAN that has been enabled as an 802.1x Guest VLAN. Guest
802.1X VLAN clients are those who have not been authorized for
802.1x or they haven't yet installed the necessary 802.1x software, yet
would still like limited access rights on the Switch.
None.
None.
144