D-Link DES-3028 Cli Reference Manual page 204

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
DES-3028P:4#show authen server_host
Command: show authen server_host
IP Address
---------------
10.53.13.94
Total Entries : 1
DES-3028P:4#
create authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the server group "group_1":
DES-3028P:4#create authen server_group group_1
Command: create authen server_group group_1
Success.
DES-3028P:4#
config authen server_group
Purpose
Syntax
Description
Parameters
Protocol Port Timeout Retransmit Key
-------- ----- -------
TACACS 49 5
Used to create a user-defined authentication server group.
create authen server_group <string 15>
This command will create an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user
defined categories for authentication using method lists. The user
may add up to eight (8) authentication server hosts to this group
using the config authen server_group command.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the newly created server group.
Only administrator-level users can issue this command.
Used to configure a user-defined authentication server group.
config authen server_group [tacacs | xtacacs | tacacs+ | radius |
<string 15>] [add | delete] server_host <ipaddr> protocol [tacacs |
xtacacs | tacacs+ | radius]
This command will configure an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user defined
categories for authentication using method lists. The user may define the
type of server group by protocol or by previously defined server group. Up
to eight authentication server hosts may be added to any particular group
server_group - The user may define the group by protocol groups built into
the Switch (TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined
group previously created using the create authen server_group command.
tacacs – Use this parameter to utilize the built-in TACACS server
protocol on the Switch. Only server hosts utilizing the TACACS
protocol may be added to this group.
xtacacs – Use this parameter to utilize the built-in XTACACS
server protocol on the Switch. Only server hosts utilizing the
--------------- ------------------
2 No Use
200