D-Link DES-3028 Cli Reference Manual page 193

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config authen_login
Parameters
Successful login using any of these methods will give the user a "user"
privilege only. If the user wishes to upgrade his or her status to the
administrator level, the user must implement the enable admin
command, followed by a previously configured password. (See the
enable admin part of this section for more detailed information,
concerning the enable admin command.)
default – The default method list for access authentication, as defined
by the user. The user may choose one or a combination of up to four(4)
of the following authentication methods:
tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the remote
RADIUS server hosts of the RADIUS server group list.
server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
none – Adding this parameter will require no authentication to
access the Switch.
method_list_name – Enter a previously implemented method list name
defined by the user. The user may add one, or a combination of up to
four (4) of the following authentication methods to this method list:
tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server.
server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
none – Adding this parameter will require no authentication to
access the Switch.
NOTE: Entering none or local as an authentication protocol
will override any other authentication that follows it on a
method list or on the default method list.
189