D-Link DES-3028 Cli Reference Manual page 56

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show config
Parameters
Restrictions
Example usage:
To view the current configuration settings:
DES-3028P:4#show config current_config
Command: show config current_config
#-------------------------------------------------------------------------------------------
#
#
#
#
#-------------------------------------------------------------------------------------------
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
# STORM
config traffic control 1 broadcast disable multicast disable dlf disable action
drop threshold 64 countdown 0 time_interval 5
config traffic control 2 broadcast disable multicast disable dlf disable action
drop threshold 64 countdown 0 time_interval 5
config traffic control 3 broadcast disable multicast disable dlf disable action
drop threshold 64 countdown 0 time_interval 5
config traffic control 4 broadcast disable multicast disable dlf disable action
drop threshold 64 countdown 0 time_interval 5
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
1. Basic (serial port, Telnet and
web management status)
2. storm control
3. IP group management
4. Syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. port
9. port lock
10. 8021x
11. SNMPv3
12. management (SNMP traps
RMON)
13. VLAN
14. FDB (forwarding data base)
15. MAC address table
notification
16. STP
17. SSH
18. SSL
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and
saved to NVRAM.
None.
DES-3028P Configuration
Firmware: Build 1.00-B22
Copyright(C) 2006-2009 D-Link Corporation. All rights reserved.
19. ACL
20. SNTP
21. IP route
22. LACP
23. ARP
24. IP
25. IGMP snooping
26. access authentication control
(TACACS etc.)
27. PoE
28. Bandwidth
29. Time_range
30. GM
31. safeguard_engine
32. Banner_promp
33. SMTP
34. AAA
35. DHCP_Relay
52