D-Link DES-3028 Cli Reference Manual page 226

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show sim
Parameters
Restrictions
Example usage:
To show the SIM information in detail:
DES-3028P:4#show sim
Command: show sim
Group Name
SIM Version
Firmware Version
Device Name
MAC Address
Capabilities
Platform
SIM State
Role State
Discovery Interval
Hold Time
DES-3028P:4#
To show the candidate information in summary, if the candidate ID is specified:
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3
(L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the
Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including
Commander, Member or Candidate. A Stand-alone switch will always
have the commander role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold discovery
results before dropping it or utilizing it.
candidates <candidate_id 1-100> - Entering this parameter will display
information concerning candidates of the SIM group. To view a specific
candidate, include that candidate's ID number, listed from 1 to 100.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a specific
member, include that member's id number, listed from 1 to 32.
group {commander_mac <macaddr>} - Entering this parameter will
display information concerning the SIM group. To view a specific
group, include the commander's MAC address of the group.
neighbor – Entering this parameter will display neighboring devices of
the Switch. A SIM neighbor is defined as a switch that is physically
connected to the Switch but is not part of the SIM group. This screen
will produce the following results:
Port – Displays the physical port number of the commander
switch where the uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor
switch.
Role – Displays the role(CS, CaS, MS) of the neighbor switch.
None.
: default
: VER-1.61
: 1.00-B22
:
: 00-35-26-11-11-00
: L2
: DES-3028P L2 Switch
: Enabled
: Commander
: 60 sec
: 180 sec
222