Rights – Specifies the level of access for an authorized user. The levels can be Read, for read only, or R/W, for
read-write.
Status – Specifies whether the current string is Valid or Invalid. This is used to temporarily limit access to the
Switch's SNMP agent.
Setup Trap Receivers
The following figure and table describe how to specify management stations that will receive authentication failure
messages or other trap messages from the Switch. Up to 4 trap managers may be entered.
Items on the screen above include:
IP Address – The IP address of the management station that will receive traps generated by the Switch.
SNMP Community String – A string of up to 20 characters used for authentication of users wanting to
receive traps from the Switch's SNMP agent.
Status – Specifies whether the current string is Enabled or Disabled. This is used to temporarily limit the
receipt of traps generated by the Switch.
Setup User Accounts
Click Setup User Accounts to access the following window:
Figure 7-57. Setup Trap Receivers screen
Figure 7-58. Setup User Accounts screen
190
8-port Gigabit Ethernet Switch User's Guide