Traps - D-Link DGS-3308 Series User Manual

In addition, you can also set an IP Address for a gateway router. This becomes necessary when the network management
station is located on a different IP network from the Switch, making it necessary for management packets to go through a
router to reach the network manager, and vice-versa.
For security, you can set in the Switch a list of IP Addresses of the network managers that you allow to manage the Switch.
You can also change the default SNMP Community Strings in the Switch and set the access rights of these Community
Strings. In addition, a VLAN may be designated as a Management VLAN.

Traps

Note: Traps are messages that alert you of events that occur on the Switch. The events can be as
serious as a reboot (someone accidentally turned OFF the Switch), or less serious like a port
status change. The Switch generates traps and sends them to the network manager (trap
recipient).
Trap recipients are special users of the network who are given certain rights and access in overseeing the maintenance of
the network. Trap recipients will receive traps sent from the Switch; they must immediately take certain actions to avoid
future failure or breakdown of the network.
You can also specify which network managers may receive traps from the Switch by entering a list of the IP addresses of
authorized network managers. Up to four trap recipient IP addresses, and four corresponding SNMP community strings
can be entered.
Note: SNMP community strings function like passwords in that the community string entered for a
given IP address must be used in the management station software, or a trap will be sent.
The following are trap types the Switch can send to a trap recipient:
Figure 5-2. Switch Information screen
16
8-port Gigabit Ethernet Switch User's Guide