Setting A Default Gateway; Setting The Administrator Password; Setting Trap Destinations; Saving Configuration Changes - D-Link DGS-3308 Series User Manual

1. Starting at the main window of the User Interface, click Configuration and then press Switch IP
Setup.
2. Enter the IP address, the subnet mask, and the management VD in the fields offered.
3. Click Apply to make the change effective. Use Save Changes on the Maintenance menu to enter
the IP address into NV-RAM.

Setting a Default Gateway

The default gateway parameter defines the IP address of a router or other network device to which IP packets are to be sent
if destined for a subnet outside of that in which the switch is operating. This parameter must be set if you are attempting
to manage the Switch from a remote network or across the Internet.
1. Starting at the main window of the User Interface, click Configuration and then press Switch IP Setup.
2. Enter the router IP address and click Apply. Use Save Changes on the Maintenance menu to enter the IP
address into NV-RAM.

Setting the Administrator Password

Management access to the Switch is restricted based on the administrator password. Administrators have read/write
access for parameters governing the SNMP agent. You should therefore assign a password to the default administrator as
soon as possible, and store it in a safe place.

Setting Trap Destinations

If you wish to record SNMP traps, or events, generated by the Switch, you must configure a destination for the IP Trap
Managers. A trap destination is the IP address of the computer system on which the Web-based manager is being run.
1. Starting at the main menu of the User Interface, click Management and then press Trap Receivers.
2. Enter the IP address and community name.
3. Move to the Status field, and select Enabled.
4. Click Apply to make the changes effective. Use Save Changes on the Maintenance menu to enter the
configuration into NV-RAM.

Saving Configuration Changes

Clicking the Apply button makes any configuration change active, but only for the current session. If the Switch is
restarted (rebooted) without entering the configuration changes into the non-volatile RAM (flash RAM), the configuration
changes will be lost.
To enter configuration changes into the Switch's non-volatile RAM, select Save Changes from the Maintenance menu.
Click on the Save Configuration button to enter the current configuration into NV-RAM. The configuration will then
be loaded into the Switch's memory when it is restarted.
8-port Gigabit Ethernet Switch User's Guide
148