GuidanceForUsers - Orion OPM-4240 User Manual

OPM-4240 / OPM-4240R
3. guidance for Users
input/Output Terminals
❶
❷
❸
❹
❼
❺
❻
❽
❾
1. RS-232C
MPDP Control, Firmware Upgrade, 9pin D-sub
2. Video
Composite Signal
NTSC, PAL, SECAM
3. S-Video
S-Video Signal
NTSC, PAL, SECAM, 4pin Mini Din
4. Component
DVD Signal
DTV - YPbPr Signal
5. PC
Computer RGB Analog Signal, D-sub 15pin
6. DVI-D
TMDS Signal
7. ID Switch
Set ID Switch
8. RS-232C(BIC)
BIC Firmware Upgrade
9. AC Input
AC 100V ~240V, 50/60Hz
14
Set iD Switch Setting
y Example of ID Switch setting
- You can set ID with 3 rotary switches as shown in the following figure.
※ When you set iD of MPDP set, power cable must be disconnected. if power cable is not disconnected
during iD setting, MPDP set may be operated with the previous iD and it may cause abnormal behavior.
※ For stable operation, wait for at least 10 seconds prior to use MPDP control program after the first aC
power connection.
y
LED indication
LED Indication
M-ON FAN
M-STB S-ON
M-ON FAN
S-ON
M-STB
M-ON FAN
M-STB S-ON
M-ON FAN
M-STB S-ON
M-ON FAN
M-STB S-ON
M-ON(Master-ON) : IP Board Master Power On.
FAN : FAN POWER ON, IF Red LED on IP board is turned on, please check FANs.
※ T o protect the product, power can be disconnected automatically when the fan is stopped.
Stand By
M-STB(Master- ) : IP Board Master Ready
S-ON(Slave-ON) : IP Board Slave Ready
Infinitely Expandable
[PDP ID 01]
100 digit 10 digit single digit
[PDP ID 15]
100 digit 10 digit single digit
LED ON OFF ON/OFF
Description
No Power.
Internal System Check after Power on.
System ready.
Power ON by MSCS Program.
(M-ON and S-ON LEDs blink every other
second. Power on status)
Power Off by MSCS Program.
(System ready).
15