Trim-Out - Pages - Hill Phoenix ONRB Installation & Operation Handbook

TRIM OUT
Now that cases have been positioned and leveled, you may proceed to trim-out case line-
up. Trim parts have been designed to be applied easily with only a small number of fas-
teners required. Most external parts are adjustable to achieve almost invisible, snug-fit-
ting joints and a high level of excellence in fit and finish.
BUMPER
JOINT
1
Adjust polymer master bumper joints,
if required. First loosen bumper
screws.
Close seam where bumper joins case 4
end. Bumper joint closes seam that
may develop if master bumper is
moved away from end to close case-
to-case joint seam.
BUMPER
SCREW
Slide bumper joint to the center of the
joint between the two cases.
screw driver in hole provided.
Seal joints along pipe chase seam
with the caulk provided.
2
Use
5
12
3
Slide master bumper left or right to
close seam as required. Bumper joint
neatly finishes any gap that may
remain.
PIPE
CHASE
Apply acrylic tape over pipe chase seam. 6
Tape is found with the ship loose items
and acts as a watershed preventing
water from settling in case joint.
ACRYLIC
TAPE