Hill Phoenix ONRB Installation & Operation Handbook page 17

Insert exterior cornice joint at every 7
case joint. The exterior cornice joints
are shipped loose with each case
MASTER BUMPER
BRACKET
Place the hook of the Streamlyne 10
bumper on the lip of the master
bumper bracket and rotate the
bumper down while pushing it in.
Once the top edge of the bumper has
slipped under the color band make
sure it is pushed in as far as it will go.
Attach the "J" rail, which is shipped 13
loose with the case. Line up the rail
with the kickplate bracket and secure
with the screws provided.
Close joints on color band by sliding
the panels together. The color band
can be moved left or right as required
to allow adjustment.
SCREW
STREAMLYNE
MASTER
BUMPER
Once the Streamlyne bumper has 11
been properly seated, attach the
bumper to the tank with the screws
provided.
ment pin into the underside of the
bumper to help align it to the bumper
on the next case.
KICKPLATE
BRACKET
"J" RAIL
Insert top of kickplate into the upper 14
kickplate retainer. Slide the kickplate
up into retainer then down on the "J"
rail.
COLOR
BAND
8
BUMPER
ALIGNMENT PIN
LOCATION
Insert the bumper align-
UPPER
KICKPLATE
RETAINER
KICKPLATE
"J" RAIL
13
STREAMLYNE
MASTER BUMPER
EXTERNAL
BUMPER JOINT
If the case has a Streamlyne front 9
style the bumper may be shipped
loose in the case. Before installing
bumper on the case install the exter-
nal bumper joint on the Streamlyne
bumper. Simply slide the joint over
the bumper for either case-to-case or
case-to-end joints.
Attach the upper kickplate retainer, 12
which is shipped loose with the case.
Line up the retainer with the kickplate
bracket and secure with the screws
provided. The kickplate brackets are
shipped loose with the ORZ and
ORZH models but come installed on
the ONRZ and ONRZH models.
Insert nose bumper into master 15
bumper channel. Roll nose bumper
into channel along entire lineup (up to
96'). We recommend that the nose
bumper be left in the store 24 hours
before installing. DO NOT STRETCH
the bumper during installation as it
will shrink to its original length and
leave a gap.
UPPER
KICKPLATE
RETAINER
KICKPLATE
BRACKET