Setting The Lsdb Overload Bit; Enabling Outputting Isis-Spb Adjacency Changes To The Configuration Terminal; Configuring The Group Mac Address For Isis-Spb - H3C S12500 Series Configuration Manual

Setting the LSDB overload bit

ISIS-SPB sets the overload bit in LSPs to notify its neighbors that it is experiencing an LSDB error condition
and cannot forward traffic correctly. During path calculation, ISIS-SPB does not choose a path as the
shortest path if the path includes the device that has the overload bit set.
You can set the LSDB overload bit when the device cannot record complete topology data in the LSDB for
memory insufficiency or any other problems.
To set the LSDB overload bit:
Step
1. Enter system view.
2. Enter SPBM view.
3. Set the LSDB overload
bit.
Enabling outputting ISIS-SPB adjacency changes to the
configuration terminal
Step
1. Enter system view.
2. Enter SPBM view.
3. Enable ISIS-SPB
adjacency change
logging.

Configuring the group MAC address for ISIS-SPB

ISIS-SPB uses a group MAC address for ISIS-SPB peer-to-peer communication. This group MAC specifies
the destination MAC address for ISIS-SPB protocol frames. Vendors might use different group MAC
addresses. You can change the ISIS-SPB control MAC for interoperability in a multivendor network.
To configure the group MAC address for ISIS-SPB:
Step
1. Enter system view.
2. Enter SPBM view.
3. Configure the group
MAC for ISIS-SPB.
Command
system-view
spbm
set-overload [ on-startup [ [ start-from-nbr
system-id [ timeout1 [ nbr-timeout ] ] ] |
timeout2 ]
Command Remarks
system-view N/A
spbm N/A
By default, ISIS-SPB outputs adjacency changes to the
configuration terminal.
log-peer-change
To display adjacency change messages on the terminal
screen, make sure the terminal logging and terminal
monitor commands are configured.
Command
system-view
spbm
control-address { all-cb | all-is |
all-l1-is | all-l2-is | all-pb }
30
Remarks
N/A
N/A
By default, ISIS-SPB does not set the
LSDB overload bit.
Remarks
N/A
N/A
The default group MAC for ISIS-SPB is
0180-C200-002E (all-pb).