Table of Contents
Advertisement
Auto-Configure
4. Operating Instructions
This fixture has 42 built in light shows. In this mode, the fixture will cycle through each of these
programs.
Please see the instructions below for details on this mode.
1.
Plug the fixture into power.
2.
Press <MENU> until AUTO appears on the LED screen.
3.
Press <ENTER> to scroll through the configurable parameters (n.***, SP.**, SF.**).
Stop when you reach n.***.
4.
Using <UP>&<DOWN>, adjust the light show progression time between 000~100. This
is the time that the fixture will run a single show before proceeding to the next.
5.
Press <ENTER> until you reach SP**.
6.
Using <UP>&<DOWN>, adjust the run speed between 00~99, FL. FL in the menu
signifies full run speed.
7.
Press <ENTER> until you reach SF**.
8.
Using <UP>&<DOWN>, adjust the strobe speed between 00~99, FL. FL in the menu
signifies full strobe speed.
9.
Press <ENTER>.
n.000~100 is used to modify the light show progression.
SP.00~99, FL is used to modify the run speed.
SF.00~99, FL is used to modify the strobe speed.
13
1/17/2011 6:15 PM
Advertisement
Table of Contents
