Security - Korenix 5010G Series User Manual

4.10 Security

The Switch provides several security features for you to secure your connection. The
features include Port Security and IP Security.
Following commands are included in this group:
4.10.1 Port Security
4.10.2 IP Security
4.10.3 IEEE 802.1x
4.10.4 CLI Commands of the Security
4.10.1 Port Security
Port Security feature allows you to
stop the MAC address learning for
specific port. After stopping MAC
learning, only the MAC address
listed in Port Security List can
access the switch and
transmit/receive traffic. This is a
simple way to secure your
network environment and not to
be accessed by hackers.
This page allows you to enable
Port Security and configure Port
Security entry.
Port Security State: Change
Port Security State of the port to
Enable first.
Add Port Security Entry: Select
the port, and type VID and MAC
address. Format of the MAC address is xxxx.xxxx.xxxx. Ex: 0012.7701.0101. Max
volume of one port is 10. So the system can accept 100 Port Security MAC addresses in
total.
Port Security List: This table shows you those enabled port security entries. You can
click on Remove to delete the entry.
Once you finish configuring the settings, click on Apply / Add to apply your configuration.
4.10.2 IP Security
In IP Security section, you can set up specific IP
addresses to grant authorization for management
access to this JetNet via a web browser or Telnet.
IP Security: Select Enable and Apply to enable IP
security function.
Add Security IP: You can assign specific IP
addresses, and then press Add. Only these IP
addresses can access and manage JetNet via a web
browser or Telnet. Max security IP is 10.
Security IP List: This table shows you added security
IP addresses. You can press Remove to delete,
97