Table of Contents
Advertisement
Lighting Griddle - Pilots
S
URFACE TEMPERATURE OF THE GRIDDLE PLATE CAN REACH OVER
OPERATED AT FULL SETTING
These griddles are fitted with a pilot as a standard option and Flame Failure Protection, which is
incorporated by way of a thermo-electric system for each main burner. Flame Failure Protection will shut
off gas supply to burner in event that pilot for that burner goes out, so that un-burnt gas is not expelled.
This is an important safety feature which is slowly becoming law throughout the world
1.
Depress gas control knob and rotate anti-clockwise to 'PILOT' position.
2.
With gas control knob held in depressed position, to ignite pilot burner, press piezo ignition button
located on griddle control panel to the right of gas control knob. (Each press of piezo igniter button
will generate a single spark).
3.
Hold 'IN' gas control knob for approximately 10-15 seconds, then release. Pilot burner should
remain alight. (If not, repeat Steps 1 to 3 above).
4.
Pilot ignition can be viewed through opening in piezo igniter plastic surround.
5.
To light remaining pilots, repeat Steps 1 to 4 above.
NOTE: If pilot burner goes out during normal operation wait 5 minutes before attempting to
re-light pilot burner.
Lighting Griddle - Main Burners
1.
Ensure pilot burner is alight by checking through opening in plastic surround fitted to piezo igniter
button on front control panel.
2.
Rotate gas control knob anti-clockwise to desired temperature marked on knob.
3.
Main burner will ignite automatically off pilot burner.
Re-Setting Overtemp Device (All UK and Optional Non-UK Models)
This griddle is fitted
with an overtemp device which isolates gas supply to burners should gas control
system or thermostat malfunction, thus preventing overheating of griddle. If pilot fails to ignite after
several attempts, ensure that overtemp is checked to ensure that it has not tripped.
1.
To reset overtemp, remove gas control
knobs from front of griddle. These are
a push fit onto spindle of gas valves.
2.
Slacken 2 screws securing front control
panel to front of griddle and carefully
remove control panel, ensuring that
leads to piezo igniter are disconnected
from rear of piezo buttons.
3.
Using a small screwdriver, depress
centre of overtemp reset button.
4.
Re-connect piezo igniter leads to rear
of piezo igniter buttons.
5.
Refit front control panel onto griddle and
secure in position with 2 securing screws.
6.
Refit gas control knobs to gas spindles.
7.
Attempt to re-light pilot burners as shown above. Should pilot burners still not ignite, call a qualified
service person to investigate problem.
Caution
.
O v e r t e m p
Reset Button
235°C
13
Operation
WHEN THE APPLIANCE IS
.
Overtemp fitted to
Gas Control Valve.
Fig 6
Advertisement
Table of Contents
