Care Of The Machine; Helpful Hints; Initial Service; Accessories - Bowflex TreadClimber 3000 Owner's Manual

Care of the Machine
The safety and integrity designed into a machine can only be maintained when the equipment is regularly
examined for damage and repaired. It is the sole responsibility of the owner to ensure that regular maintenance is
performed. The owner is responsible to make sure that regular maintenance is done. Worn or damaged
components must be repaired or replaced immediately. 0nly manufacturer supplied components should be used to
maintain/repair the equipment.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord
from the wall outlet and/or the machine and wait 5 minutes before cleaning, maintaining or repairing the machine.
Place the power cord in a secure location.
Helpful Hints
Read all of the maintenance instructions thoroughly before assembling or using the TreadClimber® exercise machine. In some
cases, an assistant is required to perform the necessary maintenance tasks. All references to the right or left side, and to the
front or back are made as if you were on the TreadClimber ® machine ready to exercise.
Initial Service
Use a soft, clean towel to wipe off the dust that may have accumulated during shipping. The TreadClimber ® machine will
require minor assembly. Refer to the Assembly Manual for details.
Accessories
For the best performance, we recommend that the TreadClimber ® machine be placed on a rubber mat. The rubber mat will
help keep dust and debris away from the TreadClimber ® machine's motor and belts, reduce noise and increase stability.
The Bowflex ®TreadClimber ® Machine Mat is professional quality and is designed specifically to fit under the Bowflex ®
TreadClimber ® fitness machine. The mat protects floors from scratches and perspiration and it gives workout areas a
clean, finished look.
For more information on this accessory and other Bowflex ® products available from Nautilus, Inc. visit:
www.bowflex.com or www.treadclimber.com.
Cleaning
General cleaning of the TreadClimber ® machine will prolong the life of the machine and improve performance. Keep the unit
clean by dusting regularly. Be sure to dust the exposed part of the deck on either side of the walking belts and the side rails.
Clean the top of the belt with a damp, soapy cloth and wipe carefully and thoroughly with a dry cloth. Be careful to keep
liquid away from inside the base frame and beneath the belts.
NOTICE: Bo not clean with a petroleum based solvent or an automotive cleaner. Be sure to keep the Console free of
moisture.
Bo not use the machine until the Walking Belts are dry.
Inspecting
1. Visually inspect the TreadClimber ® machine every time you use itfor wear, damage, or loose parts.
2. Inspect the frame for any rust, bubbling, or paint chips during the weekly cleaning. The salt in perspiration can
damage the unpainted surfaces.
3. Inspect the belts for excessive wear during lubrication. Adjust the belt tension if necessary.
6 Owner's Manual