Assembly Instructions - Spirit Z9 Owner's Manual

familiar with its function and limitations. The treadmill will stop, depending on speed,
with a one to two step coast anytime the magnet is pulled off the console. Use the red
Stop / Pause switch in normal operation.
Assembly Instructions (Z9)
ASSEMBLY PACK CHECK LIST
5/16"x 1/2" Button Head Socket Screw (14 pcs)
5/16" x 18 x 1.5T Flat Washer (6pcs)
5/16" x 23 x 1.5T Curve Washer (2pcs)
Safety Key (1pc)
Lubricant (1pc)
M5 Allen Wrench (1pc)
M6 Allen Wrench (1pc)
Assembly
•
STEP 1
Remove all parts from the carton.
•
STEP 2
Connect Computer Cable (middle) with Computer cable (lower).
•
STEP 3
Hand tighten the Left and Right Handrails into the Base with 8 pcs of 5/16" x 1/2"
Button Head Socket Screws, 6 pcs of 5/16" x 18 x 1.5T Flat Washers and 2pcs of
5/16"x 23x1.5T Curve Washers by using the M5 Allen Wrench.
•
STEP 4
Connect Speed Adjustment Switch w/Cable with Speed Cable (middle).
And connect Incline Adjustment Switch w/Cable with Incline Cable (middle).
•
STEP 5
Hand tighten the Left and Right Handrails with 4 pcs of 5/16" x 1/2" Button Head
Socket Screws by using the M5 Allen Wrench.
•
STEP 6
Connect 12 pin 1300 mm Computer Cable (middle) with 12 pin 800 mm Computer
cable (upper).
Connect Speed Cable (middle) with Speed Cable (upper) and Incline Cable (middle)
6
Z9