Maintenance Of Your New Treadmill; Belt Adjustments - Spirit Z9 Owner's Manual

Motorized treadmill

Table of Contents

STEP 4: The Pulse window will now be blinking showing age. Adjust and press enter or

press enter to accept default.

STEP 5: The Time window will now be blinking. Adjust the time and press enter.

STEP 6: Press Start to begin program.

General Maintenance

Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is

maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper

towel to wipe the edge of the belt and the area between the belt edge and frame. Also

reach as far as practical directly under the belt edge. This should be done once a month

to extend belt and bed life. Use water only - no cleaners or abrasives. A mild soap and

water solution along with a nylon scrub brush will clean the top of the textured belt.

Allow to dry before using.

Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess

off with a damp cloth will minimize buildup.

General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the

running belt. On a monthly basis, vacuum underneath your treadmill to prevent buildup.

Once a year, you should remove the black motor hood and vacuum out dirt that may

accumulate. UNPLUG POWER CORD BEFORE THIS TASK.

Treadbelt Tension Adjustment - Belt tension is not critical for most users. It is very

important for joggers and runners in order to provide a smooth, steady running surface.

Adjustment must be made from the right side of the rear roller in order to adjust tension

with the 6 mm Allen wrench provided in the parts package. The adjustment bolt is

located at the end of the right side rail as noted in diagram below.

Tracking

Tension

Adjustment

Side Only

Note: Adjustment is thru small hole of end cap.

Table of Contents