Table of Contents
Advertisement
SANTA FE FREESTANDING
6
Appliance Set-Up
A. Outside Air Kit Instructions
CAUTION
Never draw outside combustion air from:
•
Wall, floor or ceiling cavity
•
Enclosed space such as an attic or garage
Parts Included in Kit: 1 piece of 2 inch x 3 foot flex hose,
2 hose clamps, 1 air intake channel1 collar assembly, 1
termination cap assembly, 1 trim ring, 12 screws. (Discard
air channel it is not need for this appliance).
Tools Needed: Phillips head screwdriver; wire cutters; hole
saw or jig saw.
Collar
Assembly
Flex Hose
Figure 20.1
20
Hose Clamp
Trim Ring
Termination Cap
1. Measure distance from floor to air vent opening in
appliance and mark location on wall. Use a saw to
cut opening in wall. Cut a 2-1/2 to 3 inch (64-76mm)
opening on inside wall and a 3 to 3-1/2 inch (76-89mm)
opening on outside of house.
2. Remove cover plate and then install the
collar assembly.
3. Use hose clamp to secure flex pipe to collar assembly.
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second
hose clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Termination
Cap Assembly
Hose Clamp
Trim Ring
Figure 20.2
7050-801E
Flex Hose
Air Intake Channel
(Discard)
Hose Clamp
Collar Assembly
09/20
Advertisement
Table of Contents
