Full Reline With Outside Air - Quadra-Fire Santa Fe Pellet Insert SANTAFEI-B Owner's Manual

R
C. Full Reline With Outside Air
NOTE: Check clearances carefully for this
type of installation to ensure adequate room
for outside air venting.
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional,
state and national codes and regulations.
• Consult local building, fire officials or authori-
ties having jurisdiction about restrictions,
installation inspection, and permits.
Side view of Santa Fe Insert with
side panel removed.
45 degree elbow
Figure 15.1
Direct Connect
Figure 15.2
September 1, 2008
12" (305mm)
min. above
NOTE: In Canada,
only a full reline is
allowed per ULC S-
628-93, ORD ULC
C1482-M1990.
NOTE; Use metal
plate around
exhaust vent pipe
and seal all edges
with non-flammable
insulation such as
fiberglass, mineral
wool or ceramic.
Do not use high
temperature caulk-
ing materials to seal
any edge to prevent
future serviceability
Figure 15.3
7019-205C
Santa Fe Pellet Insert
12" (305mm)
min. below
Exit through the
Ash Clean-Out of
Masonry Chimney
Outside Air
Termination
at
Chimney Top
Outside Air
through
Rear Wall
Page 15