Log Set Placement - Quadra-Fire Santa Fe Pellet Insert SANTAFEI-B Owner's Manual

Santa Fe Pellet Insert
I. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
Four Piece Log Set Installation
1. Open door to expose the firebox.
2. Positioning the logs.
Place the right rear log as shown. There is a notch in
the bottom of the log for clearance for the thermocou-
ple and thermocouple cover (ceramic protection tube).
Figure 22.1.
Continue placing the last 3 logs around the firepot as
show in Figures 22.2, 22.3 and 22.4. Be careful not to
block the drop tube in the back of the firebox where pel-
lets feed into the firepot.
Notch
Thermocouple
Cover
Figure 22.1
Drop Tube
Figure 22.2
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
Page 22
Figure 22.3
Figure 22.4
Optional Firepot Top Log Installation
Place the log over the firepot. The charred
area on the log is turned toward the back, not
the front.
The log will be about 2-1/2 inches (64mm)
above the firepot when in place. It must rest
on the 3 logs in a stable position to prevent it
from falling into the firepot. Figure 21.5.
Figure 22.5
7019-205C
R
September 1, 2008