Ricoh RN-MF1 Service Manual page 92

5. System Maintenance Reference
Engine Maintenance
Registration
5
Registration
90
Adjusts the horizontal registration for the bypass tray. If the
machine settings are reset to the factory defaults, this value
Horiz.Bypass
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of plain paper for the bypass
tray. If the machine settings are reset to the factory defaults,
Vert. Bypass Plain
this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thick paper for the bypass
tray. If the machine settings are reset to the factory defaults,
Vert. Bypass Thick
this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thin paper for t the bypass
tray. If the machine settings are reset to the factory defaults,
Vert. Bypass Thin
this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the horizontal registration the back side in duplex
mode. If the machine settings are reset to the factory defaults,
Horiz. Dup. Back
this value does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of plain paper for the back side
in duplex mode. If the machine settings are reset to the factory
Vert. Dup. Plain
defaults, this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thin paper for the back side
in duplex mode. If the machine settings are reset to the factory
Vert. Dup. Thin
defaults, this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Adjusts the vertical registration of thick paper for the back side
in duplex mode. If the machine settings are reset to the factory
Vert. Dup. Thick
defaults, this value does not change.
Paper
[-40 to 40 / 0 (Default) / 0.1 mm/step]