Ricoh RN-MF1 Service Manual page 103

Fax Maintenance
Tone Signal
Transmission Time
Length
Minimum Pause In
Tone Dialing
Attenuator For
Pseudo Ring
Tone Signal Settings
Backtone To the Line
DTMF Level
DTMF Delta
Wait Time
1Dial Tone Detection
Timeout Length
Sets the tone signal transmission time length
[100 ms (Default)]
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Sets the attenuator for pseudo ringback tone to the line
[0 to 15 / 10 (Default)/ 1 dB/step]
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]
Sets the level difference between high band frequency
signals and low band frequency signals when sending
DTMF tones.
[2 dBu/ 3 dBu]
The machine starts dialing after the specified interval
without detection of a dial tone when
Dial tone detection is set to "No detection".
[3.5 Sec (Default)/ 7.0 Sec/ 10.5 Sec
/ 14.0 Sec]
This setting sets the time-out length for the 1st dial tone
detection. The machine waits for a dial tone for the
specified time and disconnects itself from the line when
no dial tone is input.
[10 Sec (Default)/ 15 Sec/ 20 Sec/ 30 Sec]
Service Program Mode
5
101