Removing An Led And Infinite Switch - Whirlpool RS160LXT Manual

REMOVING AN LED AND INFINITE SWITCH

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug range or disconnect power.
2. Remove the control panel and rotate it
forward (see page 4-2, steps 2a through
2c for the procedure).
3. To remove an LED indicator:
a) Slide LED indicator body out horizon-
tally and release the indicator body from
red LED lens.
b) Disconnect the two terminals from the
LED indicator body.
c) Remove the LED indicator body.
LED
Lens
LED Indicator
Body
4. To remove an infinite switch:
a) Remove control knob by pulling it
straight off the control shaft.
b) Remove two screws holding infinite
switch to control panel.
Switch Screws
c) Pry off infinite switch connector with
flat blade screw driver.
d) Remove infinite switch.
Infinite Switch
Connector
4-3
Infinite
Switch