Product Dimensions; Cabinet Dimensions - Whirlpool RS160LXT Manual

Product Dimensions

A
F
E**
A. 30�⁄� " (78 cm)
B. 35 �⁄�" (90.8 cm) height to underside
of cooktop edge with leveling legs
screwed all the way in*
C. Model/serial number plate (located
behind the storage drawer on the
right-hand side of the oven frame
*Range can be raised approximately 1" (2.5
cm) by adjusting the leveling legs.
**When installed in a 24" (61 cm) base cabinet
with 25" (63.5 cm) countertop; front of oven
door protrudes 2 1/2" (6.4 cm) beyond 24" (61
cm) base cabinet.
B*
C
D
D. 29 �⁄�" (75.9 cm)
E. 28 �⁄�� " (75.9 cm) from
handle to standoff at back
of range**
F. 23 �⁄�" (60.3 cm)
countertop notch to rear
of cooktop
2-3

Cabinet Dimensions

Cabinet opening dimensions shown are for 25"
(64 cm) countertop depth, 24" (61 cm) base
cabinet depth and 36" (91.4 cm) countertop
height.
If installing a range hood or microwave hood
combination above the range, follow the range
hood or microwave hood combination instal-
lation instructions for dimensional clearances
above the cooktop surface.
A
B
F
A. 13" (33 cm) upper cabinet
depth
B. 30" (76.2 cm) min. opening
width
C. For minimum clearance to the
top of the cooktop,
see NOTE*.
D. 23 �⁄� " (58.1 cm) opening
depth
NOTE: 24" (61 cm) minimum when bottom of
wood or metal cabinet is protected by not less
than 1/4" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet
steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6
mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the
top of the cooking platform and the bottom of
an unprotected wood or metal cabinet
C
D
E
G
E. 30" (76.2 cm) min. opening
width
F. Junction box - 5.5" (14 cm)
min. from either cabinet,
10" (25.4 cm) max. from floor
Outlet must be flush.
Nothing located in shaded
area can extend more than
2" (5.1 cm) from wall or range
will not slide all the way back.
G. Cabinet door or hinge should
not extend into cutout.