How To Remove The Scsi Drive Data Cable - Sun Microsystems Ultra Enterprise 450 Owner's Manual

How to Remove the SCSI Drive Data
Cable
Caution – This procedure must be performed by a qualified service-trained
maintenance provider. Persons who remove any of the outer panels to access this
equipment must observe all safety precautions and comply with skill level
requirements, certification, and all applicable local and national laws.
Before You Begin
Complete these tasks:
"How to Power Off the System" on page 26
"How to Remove the Right Side Panel" on page 32
"How to Avoid Electrostatic Discharge" on page 40
"How to Remove the Disk Fan Tray Assembly" on page 210
"How to Remove the Removable Media Assembly" on page 203
What to Do
1. Remove the screws that secure the removable media drives to their mounting
brackets, then slide the drives part way out of the bay.
This provides easier access to the SCSI cable connectors.
For drives in the upper bay, the screws are located on the sides of the drive.
(To access the screws on the divider wall, insert a screwdriver through access
holes in the right side of the removable media assembly.)
For drives in the lower bay, the screws are located beneath the drive.
Full-height devices may use either mounting scheme.
Chapter 5 Parts Installation and Repair 267